Dlp- D91 Ms-Spring Switch Test - Cisco ONS 15454 SDH Procedure Manual

DLP- D91 MS-SPRing Switch Test

If the proxy server is configured as proxy-only or is disabled, you cannot set up a firewall tunnel.
Note
Click the Provisioning > Network > Firewall tabs.
Step 1
Click Create.
Step 2
In the Create Tunnel dialog box, complete the following:
Step 3
•
•
•
•
Click OK.
Step 4
Continue with your originating procedure (NTP).
Step 5
DLP-D91 MS-SPRing Switch Test
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
From the View menu, choose Go to Network View.
Step 1
Step 2 Click the Provisioning > MS-SPRing tabs.
Step 3 Click the row of the MS-SPRing you will switch, then click Edit.
Initiate a Force Ring switch on the west port:
Step 4
a.
b.
c.
d.
Cisco ONS 15454 SDH Procedure Guide, R7.0
17-84
Source Address—Type the IP address of the source node (32 bit length) or source subnet (any other
length).
Length—Choose the length of the source subnet mask.
Destination Address—Type the IP address of the destination node (32 bit length) or destination
subnet (any other length).
Length—Choose the length of the destination subnet mask.
This task verifies that protection switching is working correctly in an
MS-SPRing.
None
DLP-D60 Log into CTC, page 17-49
Required
Onsite
Provisioning or higher
Right-click any MS-SPRing node west port and choose Set West Protection Operation. (To move
a graphic icon, click it, then press Ctrl while you drag and drop it to a new location.)
For two fiber MS-SPRings, the squares on the node icons represent the MS-SPRing working
Note
and protect channels. You can right-click either channel. For four-fiber MS-SPRings, the
squares represent ports. Right-click either working or protect port.
In the Set West Protection Operation dialog box, choose FORCE RING from the drop-down list.
Click OK.
Click Yes in the two Confirm MS-SPRing Operation dialog boxes that appear.
Chapter 17 DLPs D1 to D99
78-17194-01