Dlp- D23 View Spanning Tree Information - Cisco ONS 15454 SDH Procedure Manual

Chapter 17 DLPs D1 to D99
DLP-D23 View Spanning Tree Information
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, click the Maintenance > EtherBridge > Circuits tabs.
Step 1
In the EtherBridge Circuits window, you can view the following information:
Step 2
•
•
•
•
Return to your originating procedure (NTP).
Step 3
DLP-D24 Change an MS-SPRing Node ID
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
From the View menu, choose Go to Network View.
Step 1
On the network map, double-click the node with the node ID you want to change.
Step 2
Click the Provisioning > MS-SPRing tabs.
Step 3
Choose a Node ID number. Do not choose a number already assigned to another node in the same
Step 4
MS-SPRing.
Click Apply.
Step 5
78-17194-01
This task allows you to view E-Series Ethernet circuits and the Ethernet
front ports operating with Spanning Tree Protocol (STP). The E-Series
cards support up to eight STPs per node. For more information about STP,
refer to the Ethernet Software Feature and Configuration Guide for the
Cisco ONS 15454, Cisco ONS 15454 SDH, and Cisco ONS 15327.
None
DLP-D60 Log into CTC, page 17-49
As needed
Onsite or remote
Retrieve or higher
Type—Identifies the type of Ethernet circuit mapped to the spanning tree, such as EtherSwitch
point-to-point.
Circuit Name/Port—Identifies the circuit name for the circuit in the spanning tree. This column also
lists the Ethernet slots and ports mapped to the spanning tree for the node.
STP ID—Shows the Spanning Tree Protocol ID number.
VLANS—Lists the VLANs associated with the circuit or port.
This task changes an MS-SPRing node ID.
None
DLP-D60 Log into CTC, page 17-49
As needed
Onsite or remote
Provisioning or higher

DLP- D23 View Spanning Tree Information

Cisco ONS 15454 SDH Procedure Guide, R7.0
17-19