Dlp- D251 Set Up Or Change Routing Information Protocol - Cisco ONS 15454 SDH Procedure Manual

DLP- D251 Set Up or Change Routing Information Protocol

c.
Step 8 After entering ONS 15454 SDH OSPF area data, click Apply.
If you changed the Area ID, the TCC2/TCC2P cards reset, one at a time. The reset takes approximately
10 to 15 minutes.
Step 9 Return to your originating procedure (NTP).
DLP-D251 Set Up or Change Routing Information Protocol
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, click the Provisioning > Network > RIP tabs.
Step 1
Check the RIP Active check box if you are activating RIP.
Step 2
Step 3 Choose either RIP Version 1 or RIP Version 2 from the drop-down list, depending on which version is
supported in your network.
Set the RIP metric. The RIP metric can be set to a number between 1 and 15 and represents the number
Step 4
of hops.
By default, RIP is set to No Authentication. If the router that the ONS 15454 SDH is connected to
Step 5
requires authentication, complete the following steps. If not, continue with
a.
b.
c.
The authentication button label changes to Simple Password.
Cisco ONS 15454 SDH Procedure Guide, R7.0
19-58
Retransmit Int (sec)—Sets the time that will elapse before a packet is resent. Five seconds is the
•
default.
• Dead Int (sec)—Sets the number of seconds that will pass while an OSPF router's packets are
not visible before its neighbors declare the router down. Forty seconds is the default.
Click OK.
Table 19-4 on page 19-55
This task enables Routing Information Protocol (RIP) broadcasting on the
ONS 15454 SDH. Perform this task if you want to include the
ONS 15454 SDH in RIP-enabled networks.
None
DLP-D60 Log into CTC, page 17-49
You need to create a static route to the router adjacent to the
ONS 15454 SDH for the ONS 15454 SDH to communicate its routing
information to non-DCC-connected nodes.
As needed
Onsite or remote
Provisioning or higher
Click the No Authentication button.
In the Edit Authentication Key dialog box, complete the following:
Type—Choose Simple Password.
•
Enter Authentication Key—Enter the password.
•
Confirm Authentication Key—Enter the same password to confirm it.
•
Click OK.
shows the LED behavior during the TCC2/TCC2P reset.
Chapter 19 DLPs D200 to D299
Step 6.
78-17194-01