Tools Needed - Cisco ONS 15454 SDH Procedure Manual

NTP- D1 Unpack and Inspect the ONS 15454 SDH Shelf Assembly
Ring runs are not provided by Cisco and can hinder side-by-side shelf installation where space is limited.
Note

Tools Needed

To install the ONS 15454 SDH, you need the following tools:
•
•
•
•
•
•
•
Test Equipment
To install the ONS 15454 SDH, you need the following test equipment:
•
•
•
NTP-D1 Unpack and Inspect the ONS 15454 SDH Shelf Assembly
Purpose
Tools/Equipment
Prerequisite Procedures None
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
Complete the
Step 2
Continue with the
Step 3
Stop. You have completed this procedure.
Cisco ONS 15454 SDH Procedure Guide, R7.0
1-4
#2 Phillips screwdriver
Medium slot-head screwdriver
Small slot-head screwdriver
Video fiber connector inspection instrument
CLETOP cleaning cassette
Crimping tool—This tool must be large enough to accommodate the girth of the grounding lug when
you crimp the grounding cable into the lug.
Wire stripping tool
Voltmeter
Power meter (only for use with fiber optics)
Bit error rate (BER) tester for E1-N-14, E1-42, E3-12, DS3i-N-12, STM1E-12, and FMEC cards
This procedure unpacks the ONS 15454 SDH and verifies the contents.
Pinned hex (Allen) key for front door
Required
Onsite
None
"DLP-D1 Unpack and Verify the Shelf Assembly" task on page
"DLP-D2 Inspect the Shelf Assembly" task on page
"NTP-D2 Install the Shelf Assembly" procedure on page
Chapter 1 Install the Shelf and FMECs
17-1.
17-2.
1-5.
78-17194-01