Cisco ONS 15454 SDH Procedure Manual page 105

Chapter 2 Install Cards and Fiber-Optic Cable
NTP-D245 Route Fiber-Optic Cables
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
As needed, complete the
Step 1
for all STM-N cards except the STM-64, OC192SR1/STM64IO Short Reach, OC192/STM64 Any Reach
(STM64-XFP), and STM-16 AS cards.
Open the fold-down front door on the cable-management tray
Step 2
Figure 2-2
Route the fiber cable on the card faceplate through the fiber clip on the faceplate
Step 3
are factory-attached to the faceplate of the STM-N cards.
If you installed a 15454_MRC-12 card, complete the
Step 4
15454_MRC-12 Cards" task on page
a fiber clip that plug into the faceplate. The clip must be selected according to the cabinet door depth.
Use the short clip with the standard door and the long clip with the extended door.
GBICs, SFPs, and XFPs do not have fiber clips; therefore, if you are routing optical cable from an
FC_MR-4, E1000-2-G, G1K-4, ML1000-2, or STM64-XFP cards, skip to
78-17194-01
This procedure routes fiber-optic cables.
None
NTP-D19 Install Fiber-Optic Cables on Optical Cards, page 2-16
NTP-D286 Install the FC_MR-4 Cards, page 2-12
As needed
Onsite
None
"DLP-D45 Install the Fiber Boot" task on page
Fold-Down Front Door of the Cable-Management Tray
F A N
F A IL
C R
IT
M A
J
M IN
18-3. The 15454_MRC-12 cards are shipped with two versions of
NTP- D245 Route Fiber-Optic Cables
17-35. Fiber boots are required
(Figure 2-2).
(Figure
"DLP-D104 Install the Fiber Clip on
Step 5.
Cisco ONS 15454 SDH Procedure Guide, R7.0
2-3). Fiber clips
2-19