Dlp- D248 Delete Vlans - Cisco ONS 15454 SDH Procedure Manual

DLP- D248 Delete VLANs

Complete the
Step 5
Return to your originating procedure (NTP).
Step 6
DLP-D248 Delete VLANs
Purpose
Tools/Equipment
Prerequisite Procedures See
Required/As Needed
Onsite/Remote
Security Level
VLANs in use will not be deleted.
Note
Step 1 From the View menu, choose Go to Network View.
Step 2 From the Tools menu, choose Manage VLANS.
In the All VLANs dialog box, click the VLAN that you want to remove.
Step 3
Click Delete.
Step 4
In the confirmation dialog box, click Yes.
Step 5
Return to your originating procedure (NTP).
Step 6
DLP-D249 Provision IP Settings
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
All network changes should be approved by your network (or LAN) administrator.
Caution
If you are in network view, switch to node view by double-clicking the node you want to turn up on the
Step 1
network map.
Cisco ONS 15454 SDH Procedure Guide, R7.0
19-52
"NTP-D16 Install STM-N Cards and Connectors" procedure on page
This task removes VLANs from a domain.
None
Chapter 6, "Create Circuits and Low-Order Tunnels"
creation procedures.
As needed
Onsite or remote
Provisioning or higher
This task provisions IP settings, which includes the IP address, default
router, Dynamic Host Configuration Protocol (DHCP) access, firewall
access, and proxy server settings for an ONS 15454 SDH node.
None
DLP-D60 Log into CTC, page 17-49
Required
Onsite or remote
Superuser
Chapter 19 DLPs D200 to D299
2-7.
for circuit
78-17194-01