Dlp- D312 Provision A Half Circuit Source And Destination On An Sncp Ring - Cisco ONS 15454 SDH Procedure Manual

DLP- D312 Provision a Half Circuit Source and Destination on an SNCP Ring

Complete one of the following:
Step 4
•
•
•
•
Click Next.
Step 5
From the Node drop-down list, choose the node chosen in
Step 6
From the Slot drop-down list, choose the STM-N card to map the low-order VC3, VC11, or VC12 circuit
Step 7
for optical transport or to map the VC4 circuit to a synchronous transport module (STM).
Choose the destination from the drop-down lists that appear.
Step 8
Return to your originating procedure (NTP).
Step 9
DLP-D312 Provision a Half Circuit Source and Destination on an SNCP Ring
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
From the Node drop-down list, choose the node that will contain the half circuit.
Step 1
From the Slot drop-down list, choose the slot containing the card where the circuit will originate.
Step 2
From the Port drop-down list, choose the port where the circuit will originate. This field might not be
Step 3
available, depending on the card chosen in
Complete one of the following:
Step 4
•
•
•
•
Click Next.
Step 5
From the Node drop-down list, choose the node chosen in
Step 6
Cisco ONS 15454 SDH Procedure Guide, R7.0
20-6
For low-order VC12 circuits, choose the VC4, TUG3, TUG2, and VC12.
For low-order VC11 circuits, choose the VC4, TUG3, TUG2, and VC11.
For low-order VC3 circuits, choose the VC4 and VC3.
For high-order circuits, choose the VC4.
This task provisions a half circuit source and destination on a subnetwork
connection protection (SNCP) ring. A half circuit allows you to provision
a partial path (one end of a circuit), for example, if you want to provision
a circuit with the intent that the path will be completed at a later time or at
a different location.
None
DLP-D60 Log into CTC, page 17-49
This task can only be performed as a part of the
Circuit on an SNCP Ring Node" procedure on page
As needed
Onsite or remote
Provisioning or higher
For low-order VC12 circuits, choose the VC4, TUG3, TUG2, and VC12.
For low-order VC11 circuits, choose the VC4, TUG3, TUG2, and VC11.
For low-order VC3 circuits, choose the VC4 and VC3.
For high-order circuits, choose the VC4.
Step 1.
Step 2.
Step 1.
Chapter 20 DLPs D300 to D399
"NTP-D140 Create a Half
6-70.
78-17194-01