Renault Laguna III Manual page 3698

Heated seat cover: Removal - Refitting
REFITTING
I - REFITTING OPERATION FOR PART
CONCERNED
a
IMPORTANT
T o ensure the pyrotechnic components operate
correctly:
- do not bend the passenger presence sensor
pad,
- do not apply glue or adhesive to the passenger
presence sensor pad or to the seat cushion
trim.
a The new heated seat cover must be adhered to the
remaining strips from the previous heated seat co-
ver.
II - FINAL OPERATION.
a Refit the front seat foam or front seatback foam.
a Connect the heated seat cover connector.
a Refit the front seat (see 75A, Front seat frames
and mechanisms, Complete front seat: Removal
- Refitting, page 75A-15) .
a Connect the battery (see Battery : Removal - Refit-
ting) (MR 415, 80A, Battery).
a Carry out a function test.
a Disconnect the battery (see Battery : Removal -
Refitting) (MR 415, 80A, Battery).
a Remove the front seat (see 75A, Front seat frames
and mechanisms, Complete front seat: Removal
- Refitting, page 75A-15) .
a Refit:
- the front seatback trim (see 77A, Front seat trim,
Front seatback trim: Removal - Refitting, page
77A-3) or the front seat cushion trim (see 77A,
Front seat trim, Front seat base trim: Removal -
Refitting, page 77A-1) ,
- the front seat lower covers (see 77A, Front seat
trim, Front seat lower cover: Removal - Refit-
ting, page 77A-8) ,
- the entire front seat (see 75A, Front seat frames
and mechanisms, Complete front seat: Remo-
val - Refitting, page 75A-15) .
a Connect the battery (see Battery : Removal - Refit-
ting) (MR 415, 80A, Battery).
SEAT COMPONENTS
79A-2
79A