Setting The D/480Jct-T1-Ew And D/600Jct-E1120-Ew Boards; Setting The D/82Jct-U-Ew Board - Avaya S8730 Maintaining Manual

Adding and replacing an MAS port board
1. Remove the port board from its protective packaging and set it on an antistatic mat .
2. Remove the card retainer bracket that is attached to the board opposite the
3. Set the jumpers and switches required for the type of board you are installing.
Setting the D/480JCT-T1–EW and D/600JCT-E1120–EW boards
Prerequisites
Determine in which slot in the PCI cage you will be installing the board. Slots in the PCI cage are
number 3 (bottom slot), 4 (middle slot) and 5 (top slot). If a system has one board, install it in
slot 3 (bottom). If it has two boards install them in slots 3 (bottom) and 4 (middle). If it has three
boards install them in slots 3 (bottom), 4 (middle) and 5 (top).
For the D/480JCT-T1–EW and D/600JCT-E1120–EW boards, set the board ID and turn off
power budgeting.
1. Turn the SW100 rotary switch located on the top of the board to set the board ID
2. Move the P3 jumper on the top of the board on to pins 1–2 to disable power
Setting the D/82JCT-U–EW board
If a system has one board, install it in slot 3 (bottom). If it has two boards install them in slots
3 (bottom) and 4 (middle). If it has three boards install them in slots 3 (bottom), 4 (middle) and 5
(top). For the D/82JCT-U-EW board, set Computer Telephony (CT) bus termination and turn
28 Maintaining the Avaya S8730 Server for Modular Messaging
Handle the board by the edges and avoid touching the board's components.
faceplate.
You can discard the bracket and screws.
according to the number of the slot in which the board is installed.
PCI slot number
3
4
5
budgeting.
Board ID number
0
1
2
June 2009