Acura 1994 Integra Service Manual page 68

-
'14.
Valve Seals
Replacement (cylinder head removal not required) (cont'dl
' 1 1 .
Using a downward motion on the lever arm. com-
press the valve spring and remove the keepers from
t h e v a l v e s t e m . S l o w l y r e l e a s e p r e s s u r e o n t h e
spring.
Repeat step l1 for the other valve in that cylinder.
Remove the valve seals (see page 6-22).
Installthe valve seals (see page 6-23).
Install the springs, the retainers and the keepers in
reverse order of removal.
16. Repeat steps 9 to l5 for the other three cylinders.
ExhaGt Valvs Soals
17. Using the 6 mm bolts supplied with the tool, mount
t h e t w o u p r i g h t s t o t h e c y l i n d e r h e a d a t t h e e n d
camshaft holders. The uprights fit as shown.
18. Insert the cross shaft through the bottom hole of
the two uprights.
Select the 7/8 in. diameter short compressor attach-
ment and fasten the attachment to the No. 4 hole of
the lever arm with the speed pin supplied.
Position the piston at TDC and insert an air adaptor
into the spark plug hole. Pump air into the cylinder
to keep the valve closed while compressing springs
and removing the valve keepers.
1 9 .
20.
21. Position the lever arm unde. the cross shaft so the
lever is perpendicular to the shaft and the compres-
sor attachment rests on top of the retainer for the
spring being compressed. Use the rear position slot
on the lever as shown.
N O T E : P u t s h o p t o w e l s o v e r t h e o i l p a s s a g e s t o
prevent the valve keepers from falling into the cylin-
der head.
Using a downward motion on the lever arm, com-
press the valve spring and remove the keepers from
t h e v a l v e s t e m . S l o w l y r e l e a s e p r e s s u r e o n t h e
spring.
Repeat step 22 for the other valve in that cylinder.
Remove the valve seals (see page 6-22).
Install the valve seals (see page 6-23).
Install the springs, the retainers and the keepers in
reverse order of removal.
Repeat steps 20 to 26 on the other three cylinders.
NOTE: Reler to page 6-31 when installing cylinder
neao cover.
OIL PASSAGE
27.