Removal - Acura 1994 Integra Service Manual

Cylinder Head
Removal
Engine removal is not required or this procedure.
CAUTION: To avoid damaging tho cylinder head, wail
u[tilths.nginc coolant tsmperaturo drops bolow 100"F
(38'Cl bafore loos6ning tho retaining bolts.
NOTE;
. Inspect the timing belt before removing the cylinder
head.
Turn the crankshaft pulley so that the No. 1 piston is
at top dead center (TDc) {page 6-51).
Mark all emissions hoses betore disconnecting them.
Anti-theft radios have a coded theft protection circuit.
Be sure to get the customer's code number before
-
Disconnecting the battery.
-
Removing the No.32 (7.5 A) fuse trom the under-
hood fuse/relay box.
-
Removing the radio.
After service, reconnect power to the radio 8nd turn it
o n .
When the word "CODE" is displaved. enter the cus-
tomer's 5-digit code to restore radio operation,
Disconnect the negative terminal from the battery.
Drain the engine coolant (see page 10-5).
. Remove the radiator cap to speed draining.
Relieve fuel pressure (see section 111.
l@
Do not 3moke whilo working on fuel
a
a
'1.
systgm. ko6p opon tlamo ot Spark away trom work
aroa. Drain fugl only into an approved containsr,
4.
Disconnect the fuel feed hose.
SERVIC€ BOLT
15 N.m (1.5 kgtm, rl bf.tt)
WASHERS
Replace.
BANJO BOLT
5. Remove th€ strut brace,
6. Remove the intake air duct.
8 x 1.25 mm
24 N.m (2.1kg[.m, 17 lbtftl
INTAKE AIR
(cont'd)
6-5 5