Acura 1994 Integra Service Manual page 935

1 2. Scrape o. wipe the excess adhesive ofJ with a Dut-
ty knife or gauge.
NOTE: Clean the molding and rear window surface
with alcohol where upper seal is to be apptied.
{Gla*r Surtacel
Surfaco to be
wiped clean.
{Gla$ Insido Surtacel
13. Apply the upper seal to the inside face of glass (see
page 2O-621.
14. After the adhesive is dry, use suction cups to hold
the rear window over the opening, set the rear win-
dow on the hatch, then center it in the opening.
SUCTION CUPS
1 mm (0.04 In)
1 5. Scribe a line on the molding lip with a greas€ pencil
to show the cutting portion ot the molding lip, as
shown.
16. Cut the molding lip off, as shown.
MOLDING LIP
17. Close the hatch, then check the gap between the
molding lip and body.
18. lf the molding lip contacts the body, cut the mold-
ing lip off. keeping the gap para el wiih the body.
20-67