Acura 1994 Integra Service Manual page 59

Insrall the left front mount, then tighten the bolts in
the numbered sequence as shown (O-@),
O 12 x 1.25 ]n]n
83 N.m 18.5 kst.m,61 lbt.ftl
Replace.
@ 1 2 r 1 . 2 5 m m
59 N.m {6.0 kgl.n,
43 tb{.ftl
Replace.
@ 1 0 r 1 . 2 5 m m
44 N.m (4.5 kgf.m, 33 lbt.ftl
k -
5 - 1 5
a Check that the sp.ing clip on the end of each
driveshaft clicks into place.
GAUTION: Uso oow spring clips.
a Bleed air trom the cooling system at the bleed bolt
with the heater valve open (see page 10-5).
a Adjust the th.ottle cable (see section 1 1).
a Check the clutch pedal tree play lsee section 12).
a Check that the transmission shifts into gear
smoothlv,
a Adiust the tension of the following drive belts.
Alternator belt {s€e section 23).
P/S pump belt {see section 17).
A/C comoressor belt (see section 22).
a Inspect tor fuel leakage (see section 1 1).
. After assembling fuel line parts, turn on the ig-
nition switch (do not operate th€ starter) so
that the Juel pump operates for approximat€-
lV two seconds and the tuel line pressurizes.
Repeat this operation two or three times and
check for fuel leakage at any point in the fuel
l i n e .
(cont'd)