Acura 1994 Integra Service Manual page 104

Valve Clearance
Adiustment
NOTE:
. Valves should be adjusted cold; at a cylinder head
temperature of less than 100"F (38'C).
. A d j u s t m s n t i s t h e s a m e f o r i n t a k e a n d e x h a u s t
vatves.
o After adjusting, retorque the crankshaft pulloy bolt to
177 N.m ( 18.0 kgf.m, 130 lbf.ft).
1. Remove cylinder head cove..
ADJUSTING BOLT LOCANONS:
IMTAKE
No. 4
No.3 No. 2 No. 1
N o . 4 N o . 3
N o . 2
N o . 1
EXHAUST
Set No. 1 piston at TDC. "UP" mark on the pulley
should be at top, and TDC grooves on the pulley
should align with the pointer on back cover. TDC
g r o o v e s ( w h i t e p a i n t ) o n t h e c r a n k s h a t t p u l l e y
should align with pointer on the timing belt lower
cover.
Numbr. 1 pirton .t TDC:
6-44
FOI{IER Ot{
LOWEF COVER
TDC MANK
lP.int d whit.t
3.
4.
Diroction of
aotation.
Adjust valv6 clearanc6 on No. 1 cylinder.
Intlkc:
0.15 - 0.19 mm (0.006 - 0.0,07 inl
Exh.u3t 0.17 - 0.21 mm (0.007 - 0.m8 inl
Looson lh6 locknut and turn the adjusting screw
until feeler gaugo slides back and fonh with a slight
amount of drag.
TAPPET AI\,USTEN WREI{CI{
O'LAA - PRIOIq'
7 x 0.75 mrn
20 f+|n (2.0 kgf'm. 14lbtftl
FEEEN GAUGE