Acura 1994 Integra Service Manual page 519

Mainshaft
Disassembly/lnspection/Reassembly
NOTE:
a Lubricate all pans with ATF during reassembly.
a Install the thrust needle bearings with unrolled edge of bearing retainer lacing washer.
a Inspect the thrust needle bearings and the needle bearings for galling and rough movement.
a Betore installing the O-rings, wrap the shaft splines with tape to prevent damaging the O-rings.
a Locknut has lett-hand threads.
RING
\
MAINSHAFT
Check splines tor excessive
wear or damage.
Check bearing surface for scoring,
scralches or excessive wear,
CONICAL SPRING WASI{ER
Replace.
LOCKNUT (FLANGE NUT)
1 9 x 1 . 2 5 m m
93 N.m {9.5 kgf.m, 69 lbf.ftl
Replace.
Left-hand threads
SNAP
THRUST WASHER
THRUST NEEDLE
BEARING
lST CLUTCH
ASSEMBLY
o-ntNGs
Replace.
THRUST WASHER
THRUST NEEDLE
BEARING
4TH GEAR
NEEOLE BEARIT{GS
4TH GEAR COLLAR
lST GEAR
THRUST WASHER
BEANING
1ST GEAR
COLLAR
TRANSMISSION
HOUSING BEARING
SEALING RINGS,
35 mm
2ND/4TH CLUTCH
ASSEMBLY
NEEDLE BEARING
THRUST NEEDLE
BEARING
O.RINGS
Replace.
THRUST WASHER, 36.5 x 55 mm
Solective part.
THRUST NEEDLE
BEAFING
2ND GEAR
SEALING RING.
29 mm
NEEDLE BEARING
SET RII{G