Acura 1994 Integra Service Manual page 520

Mainshaft
Inspection
a Clearance Measurement
NOTE: Lubricate all parts with ATF during assembly.
1 . Remove the mainshaft bearing lrom the transmission
h o u s i n g ( s e e p a g e 1 4 - 1 5 2 ) .
2. Assemble the parts below on the mainshaft.
NOTE: Do not assemble the O-rings while in-
specting.
LOCKNUT
/
1ST CLUTCH ASSEMBLY
THRUST WASHER
lST GEAR COLLAR
TBANSMISSION
HOUSING BEARING
THRUST WASHER
4TH GEAR COLLAR
2ND/4TH CLUTCH
ASSEMBLY
THRUST WASHER
Selective part.
TI{RUST NEEDLE
BEARING
2ND GEAR
NEEDLE BEARING
THRUST NEEOLE
BEARING
MAINSI.IAFT
14-130
3RD GEAR
2ND GEAR
Torque the mainshaft locknut to 29 N.m (3.0
kgf .m, 22 lbf.ft).
NOTE: Mainshaft locknut has lett-hand threads.
29 N.m (3.0 kgl.m, 22 lbt.ft)
4.
Hold 2nd gear against the 2nd clutch. then meas-
ure the clearance between 2nd gear and 3rd gear
with a feeler gauge.
NOTE: Take measurements in at least three Dlaces
and take the average as the actual clea.ance.
STANDARD: 0.05-0.13 mm {0.002-0.005 inl
THRUST WASHER-
36.5 x 55 ftm
3RD GEAR
2ND GEAR