Pressure Testing
(cont'dl
a
Clutch Low/High P.essure Measuroment
@[
wtite resring. b€ calefut ot tha loraring
flont wh66ls.
- 1. Allow the front wheels to rotate freely.
-2.
Remove the cable end of the throttle control cable
from the throttle control lever.
NOTE: Do not loosen the locknuts. simplv unhook
the cable end.
CAALE END
-3.
Start the engine and let it idle.
-4.
Shitt the select leve. to E
position.
-5.
Slowly move the throttle linkage to increase engine
rpm until pressure is indicaied on the oil oressure
gauge.
Then release the throttle linkage, allowing the en-
grne to return to an idle, and measure the Dressure
resding.
14-96
-6.
With the engine idling, lift the throttle control lever
up approximately 1/2 of its possible travel and in-
crease the engine rpm until pressure is indicated
on the gauge, then measure the highest pressure
reading obtained.
- 7. Repeat steps 5 and 6 for each clutch pressure be-
ing inspected.