Acura 1994 Integra Service Manual page 559

shift cable
Removal/lnstallation
a All SRS electrical wiring hamosses are covor€d with
yellow insulation.
a Before disconnecting any pan ot th€ SRS wire har-
noss, connect the short connectorc (soe page 23-7O1.
a Roplace th€ entiro attect€d SRS haness assembly it
it has an open circuit ot damaged wi.ing.
@@[
uar"
sul€ litts are placed proparty {so6
section 1).
1. Remove the center console {see section 20).
2.
Shift to N position. then remove the lock pin from
the cable adjuster.
@ J ^ l l
AJUI
[ q J ] l
t l
---l
LOCK NUT
7 N.m
(O.7 kgf.m, 5 lbf.ft)
14-170
3. Remove the shift cable bracket.
6 x 1 . 0 m m
1 2 N . m 1 1 . 2 k g f . m , 4 . 7 l b f . f t l
4. Remove the shitt cable holder.
5. Remove the shift cable cover.
6. Remove the control lever from the control shaft, then
remove the shift cable. Take care not to bend the
cable when removing/installing it.
SHIFT CABLE I{OLDER
Install the shift cable in the reverse orde. of removal.
Check the cable adjustment on reassembly, on page
1 4 - 1 7 1 .
7 .
8 .
12 N.m 11.2 kgf.rh, 8.7 lbf.ftl
14 N.m 11.4 kgl.m, 10lbt.ft)