Acura 1994 Integra Service Manual page 914

Doors
14. Adjust clearance "8" as follows.
"8" (see page 20-421
Lower the glass 1O mm {0.39 in).
Push the glass outward 1O mm (O.39 inl. then
push the inside stabilizers against the glsss light-
ly. Fasten the inside stabilizers.
NOTE: Check that the glass moves smoothly.
Glass Adjustment (cont'dl
- l
- 2
20-46
-3 Loosen the upper locknut on the center glass
guide, and turn the adiusting bolt until cleatance
"B" is within the soecified value.
ADJUSTING EOLT
LOCKNUT
1 2 x 1 . 2 5 m m
22 N.m 12.2 kgf.m,
16 tbt.ft)
*
GLASS
NOTE: Do not adjust the lower adjusting bolts
on the center glass guide.
-4 Move the glass up and down to seat it, then
measure clearance "8" at the designated lo-
cattons.
- 5 Measure clea.ance "H" again to make sure it
is still wilhin the specified limits at the desig-
nated locations.
NOTE: Repeat the above steps until the correct
clearances afe obtained.