Acura 1994 Integra Service Manual page 548

18. Install the sub-shaft assembly in the transmission
h o u s i n g { s e e p a g e 1 4 - 1 3 8 ) .
19- Install the reverse idler gear and gear shatt holder
( s e e p a g e 1 4 - 1 5 4 ) .
20. Install the differential assembly in the torque con-
verter housing.
21. Install the mainshaft and countershaft sub-assembly
together in the torque converter housing.
MAINSHAFT
SUB.ASSEMBLY
COUNTERSHAFT
SUB.ASSEMBLY
2 2 . Turn the shift fork so the large chamtered hole is fac-
ing the fork bolr hole. then installthe shift fork with
the reverse selector and torque the lock bolt. Bend
the lock tab against the bolt head.
SHIFT FORK
LOCI( WASHER
Replace.
6 x 1 . 0 m m
4 N . m
(1.4 kgl.m, rO lbt.ft)
Large chamfered hole
faces this way.
, , 1
24.
lnstall the reverse gear with the collar and needle
bearing on the countershalt.
Align the spring pin of the control shaft with the
transmission housing groove by turning the control
shalt.
Place the transmission housing on the torque con-
verter housing with a new gasket and the dowel pins.
CONTROL
/K"\
/ / 2 " \
TRANSMISSION HOUSING
Install the transmission housing bolts along with the
t.ansmission hanger and the connector stay, then
torque the bolts in two or more steps in the sequence
s h o w n .
TOROUE: 44 N.m (4.5 kgf.m, 33 lbf'ft)
TRANSMISSION
HANGER
25.
CONNECTOR
1 4 - 1 5 9