Acura 1994 Integra Service Manual page 599

Driveshafts
Reassembly (cont'dl
1. Wrap the splines with vinyl tape to prevent damage
to the boots and dynamic damper.
2 . I n s t a l l t h e o u t b o a r d b o o t , d y n a m i c d a m p e r a n d
i n b o a r d b o o t t o t h e d r i v e s h a f t , t h e n r e m o v e t h e
vinyl tape.
CAUTION: Take care not to damage the boots and
dynamic damp€r.
DYNAMIC DAMPER
INBOARD BOOT
Installthe stopper ring into the driveshaft groove.
NOTE: Always rotate the stopper ring in its groove
to be sure it is fully seated.
Install the spider on the driveshaft by aligning rhe
marks on the spider and end of the driveshaft.
Fit the circlip into the driveshaft groove.
NOTE: Always rotate the circlip in its groove to be
sure it is fully seated.
VINYL T
,.%
CIRCLIP
SPIDER
STOPPER RING
OUTBOARD BOOT
1 6 - 8
6.
Pack the outboard joint with the joint grease includ-
ed in the new driveshaft set,
Grease quantity: 90 - 100 g (3.2 - 3.5 oz)
7 . Fit the rollers to the spider with their high shoulders
facing outward.
NOTE:
. Reinstall the rollers in their original positions on
the spider by aligning the marks.
.
H o l d t h e d r i v e s h a f t p o i n t e d u p t o p r e v e n t t h e
rollers from falling off.
+ {l-
-r
SPIDER
ROLLER
{For left driv8hattl
ROLLER