Acura 1994 Integra Service Manual page 931

7 . Set the rear window upright on the hatch, then
center it in the opening. Make alignment marks
across the rear window and body with a grease pen-
cil at the tour points shown.
ALIGNMENT MARKS
Remove the rear window.
Center and glue the side rubbe. dams to the inside
face of the rear window, as shown, to contain the
adhesive during installation.
NOTE:
a Glue the side rubber dams, using the printed dots
as a guide-
a Be careful not to touch the rear window, where
adhesive will be applied.
a Mask off surrounding surfaces before applying
pnmeI.
8 .
cl
REAR WINDOW
1O. Install the rear window trim.
1 1. With a sponge, apply a light coat of glass primer
around the edge of the rear window, then lightly
wipe it ott with gauze or cheesecloth.
NOTE:
a Do not apply body primer to the rear window, and
do not get body and glass primer sponges mixed
u p .
a Never touch the primed surfaces with your hands.
lf you do, the adhesive mav not bond to the rear
window properly, causing a leak after the rear
window is installed.
a Keep water, dust. and abrasive materials awav
from the primed surlace.
////
, appV glass primor hero.
NOTE: Apply the glass primer,
using the printed dots as a
guroe.
MOLOING
UPPER
15 mm
(0.0a inl
1 5 m m
{0.6 in}
(cont'd)
10.6 inl
MOLDING
REAR WINDOW
20-63