Acura 1994 Integra Service Manual page 948

Moonroof
Motor, Drain Tube and Frame Replacement
CAUTION: B€ caretul not to damag€ lhe seats, dash-
board and other interior trim.
1. Remove the glass (see page 2O-79) and headliner
(see page 20-98).
2.
Disconnect the motor connector, and remove the
clips securing the ceiling light wire harness.
3. Remove the bolts and nuts, then remove the motor,
if necessarv,
NOTE: Make sure both sliders are parallel when in-
stalling the motor.
: 8olt, nut locationg
A
: Bolt, 2
6 x 1 . O m m I
9 . 8 N . m I
Ld
tt.o kgf.-,
I
,.?- ", _,/
< : CliD locations. 2
CEILIING LIGHT
FRAME
B : N u t , 3
20-80
4.
Disconnect the drain tubes.
Remove the bolts, then remove the trame from the
car.
NOTE: You may require assistance when removing
the frame.
: Eolt locations, I
6 x 1 . 0 m m
DRAIN TUBE
To install, slide the drain
tube over the ftame nozzle
at least 10 mm {O.4 in}.
6 .
TUBE CI-IP
Pull the drain tubes out the front and rear pillars.
NOTE; Betore pulling out the drain tube, tie a string
to the end of it so it can be reinstalled.
Installation is the reverse ol the removal procedure.
NOTE:
a Clean the surtace of the frame.
a Check the trame seal.
a Check for water leaks.
7 .
9 . 8 N . m ( 1 . 0 k g t m ,
7.2 rbr.ttl
)
FRAME
FRONT