Acura 1994 Integra Service Manual page 963

Roar pillar tlim panel/Rear shell trim panel/Rsar she
removal:
1. Remove both seat-back side bolsters {see page
2 0 - 1 1 1 ) .
2. Remove the upper portion of the rear door sill mold-
ing, then pull the rear door trim awav on each side.
REAR PILLAR TRIM PANEL
3. Remove both rear pillar trim panels.
> i Clip localionr, 12
W.,
NOTE: When installing, make sure
REAR PILLAR
TRIM PANEL
the rear window defogger wire
harness is .outed properly.
> : Clip locations, 2
4. Bemove the rear shelf trim panel.
V : Clip locrtions, 2
f r l
^affi-_--.]-"t't
Y,r\-J/ '/
\t -
REAR sHEr-F
-
TRIM PANEL
5. Slip the rear seat belr through the slit in the rear shelf.
REAR SHELF
6 . R e m o v e t h e s e a t l o c k c o v e r { s e e p a g e 2 0 1 1 1 ) a n d
high mount brake lighr (see section 23).
(cont'd)
20-95