Acura 1994 Integra Service Manual page 298

Fuel Supply System
Fuel Pump (cont'dl
Tc.ting
@E
o" not smoko during tho tesr. Koop open
flrmo away fiom your work area.
lf you susp€ct a problem with the tuel pump, check that
the lusl pump actually runs; when it is ON, you will hear
some noise if you hold your ear to the luel lill oon with
the fuel fill cap remov6d. The fuel pumD should run for
two seconds, when ignition switch is first turned on. ll
the fuel pump does not make noiss, check as tollows;
1. Removo the rear seat (see section 2O).
-'2.
Remove the access panel.
3. Disconnect the 2P connector from the fuel pump.
CAUTION: 86 lure to tum th6 ignition switch OFF
botor6 disconnoctlng th€ wilos,
4.
Connect the BLK|yEL @ wire 8nd YEL/GRN @ wire
with a iumpe. wire 8t the PGM-FI main relav con-
nectot.
l.t,
.--/
re
-Fl
.\
.
MAll{ RELAY
BL&
YEL
Jumper
Check that battery voltage is available at the tuel
pump connector when the ignition switch is turned
ON (positive probe to the YEL/GRN wire, negative
probe to ths BLK/WHT wire).
ACCESS
PANEL
side
YEL/
GRN
a lf battery voltage is available, replace the fuel
pump.
a It there is no voltage, check the tusl pump ground
and wire harness {see page I 1-1 l2).
1 1 - 1 1 0
Roplacomont
@
oo not smoks whilo worklng on fuel syr-
tem. Kaop opon llamos away from your wolk araa.
1. Remove the rear ssats {soe section 2O).
2. Remove the access oanel.
3.
Disconnect the 2P connector from the fuel pump.
4.
Remove the fuel pump mounting nuts.
5. Remove the fuel pump trom the luel tank.
6.
Install a new washer on the banio bolt, then install
Darts in the revers€ order of removal.
6 N.m
lO.6 kgl.m,.
4 tbt.ftl
27
.m
(2.4 kgt.m,
21 tbt.ftl