Acura 1994 Integra Service Manual page 483

Stall Speed
CAUTION:
a To plevent transmission damage, do not test stall speed fot mote than 1O seconds at a time.
a Do not shift the level while raising th€ engine speed.
a Be sure to remove the pressure gauge belot€ testing stall speed.
1. Engage the parking brake and block all four wheels.
2. Connect the tachometer, and start the engine.
3. Make sure the A/C switch is OFF.
4. After the engine has warmed up to normal operating temperature (the cooling lan comes on), shift into ft position.
5. Fully depress the brake pedal and accelerator for 6 to 8 seconds. and note engine speed.
6. Allow 2 minutes for cooling, then repeat the test in [,
fDil and @ positions.
N O T E :
a Stall speed tests should be used lor diagnostic purposes only.
. Stall speed should be the same in E,
tr. tr and @ positions.
Stall Speed RPM: rpm
Specification: 2,400 rym
Service Limit: 2,2OO-2,600 tpm
TROUBLE
PROBABLE CAUSE
Stall rpm hish in E,
E, I
and @
posrtron
Low fluid level or oil pump output
Cloqged ATF strainer
Pressure regulator valve stuck closed
Slipping clutch
Stall rpm high in I position
Slippage of 1st clutch, 1st-hold clutch or 1st gear one-way clutch
Stall rpm high in @ position
Slippage of 2nd clutch
Stall rpm high in @ position
Slippage of 1st clutch, lst gear one-way clutch
Stall rpm high in @ position
Slippage of 4th clutch
Stall rpm low in E,
E, I
ana @
position
Engine output low
Torque converter one-way clutch slipping
14-92