Acura 1994 Integra Service Manual page 601

Driveshafts
Position the dynamic damper as shown below.
.
Install a new dynamic damper band. and bend
down both sets of locking tabs.
Lightly tap on the doubl€d-over ponion of the
band to reduce its height,
Loft/Right 29 r 2 mm (1.1 r 0.1 inl
DYNAMIC DAMPER
t 5 .
Reassembly (cont'dl
DYNAMIC DAMPER BANO
Installation
1. Install the outboard joint into the knuckle.
KNUCIGE
Apply 1.0 - 1.5 s (0.04 - 0.05 oz) of specified groase
to the whole splined surtace of the intermediats
shaft.
NOTE: After applying grease, remove the grsase
f.om the splined grooves at intervals of 2 - 3 sDlines
and from the set ring groove so air can bleed from
the inboard joint.
Install the new set ring onto the driveshaft or inter-
mediate shaft groove.
CAUTION: Always uso a now sot ring whcncycr
tho driveshaft is boing in3tallod.
RING
b
OUTBOARD JOINT
1 6 - 1 0
SET RING GROOVE