Acura 1994 Integra Service Manual page 355

Change Holder Assembly
Clearance Inspection {cont'd}
7, Measure the clearance between the select arm
t h e 1 0 m m s h i m .
Stsndard: 0.01 - 0.2 mm (0.0004 - 0.008 inl
8. lf the clearance is not within the standard. select
and install the appropriate 10 mm shim for the cor-
rect clearance from the chan below.
10 mm Shim
SETICT ABM
10 mm SHIM
Part Numbsr Thickn€ss
2 4 4 3 5 - 6 8 9 - 0 0 0
0.8 mm (0.03'l in)
B 2 4 4 3 6 - 6 8 9 - 0 0 0
'1.0 mm (0.039
in)
2 4 4 3 7 - 6 8 9 - 0 0 0
1 . 2 m m ( 0 . 0 4 7 i n l
2 4 4 3 8 - 6 8 9 - 0 0 0 1 . 4 m m { 0 . 0 5 5 i n )
2 4 4 3 9 - 6 8 9 - 0 0 0
1.6 mm (0.063 in)
13-14
SHIFT ARM HOLDER
9. Measure the clearance between the shift arm holder
and the change piece.
Standard:
0.05 - 0.35 10.002 - 0.01i1 in)
Sorvico Limit: 0.8 mm (0.03 in)
ll the clearance is more than the service limit. mea-
sure the groove of the change piece.
Standafd: 12.05 - 12.15 mm {0.47ilil - 0.iU83 in)
lf the groove is not within the standard, replace
the change piece with a new one.
lf the groove is within the standard, replace the
shift arm holder with a new one.
1 0 .