Acura 1994 Integra Service Manual page 665

4 1 .
Install a puller yoke to the steering gearbox, then
clamp the puller yoke in a vise with soft jaws as
shown.
PULLER YOXE:
Commcrcirlly Avrihblo
Sn.p-Ono T/N Cr123-l
orco T/N 7372
or aquivrlani
Grease the inside surface of the cylinder end, then
install the cylinder end by screwing it into the cylin-
d e r h o u s i n g .
After tightening the cylinder end, stake the point of
the cylinder housing shown below.
NOTE: Stake in the cylinder in the position opposite
from where the stake was removed during disas-
semblv.
Strke point, D.pth: 1.0 mm (0.04 inl
4.0 mm 10.15 inl
CYLINDER HOUSING
CYLINDER END
CYLINOER
69 N.m 17.0 kgf.m, 51 lbtft)
,t8. Select the 32 mm shim(s).
N O T E : O n l y r e i n s t a l l t h e o r i g i n a l 3 2 m m s h i m ( s )
when the steering gearbox is reassembled without
replacing the pinion shaft, valve housing, and gear-
box housing with new ones.
l f t h e p i n i o n s h a f t , v a l v e h o u s i n g , a n d g e a r b o x
housing are replaced, select the new shim{s) as fol-
rows.
Shim r€lection:
-'1. Set the four 32 mm shims on the b€aring surface of
the gearbox housing. Total thickness of the four
shims should eoual no more than 0.70 mm.
Shim set: tour 32 mm shims (Thickness: 0.10 mm,
0.15 mm, 0.20, 0.25 mm respectivelyl
CAUTION: The tour 32 mm shimr do not hlva
thlckn$s idcntitication mukt. Mo!3ur. tho thicl-
oa33 of rach 3him using a miclomctrl, and mlrk
tho shim lor id6ntific8tion.
- 2 . I n s t a l l t h e v a l v e b o d y u n i t o n t h e g e a r b o x , a n d
tighten the flange bolts to the specitied torque
VALVE BODY UNIT
FLANGE BOLT
20 N.m {2.o kgtm, 14lbt'ftl
SHIM SET
{foul thim.)
Measure the clearance between the gearbox and
valve body unit using a feeler gauge as shown.
NOTE: Measure the clearance at the point midway
between the two mounting bolts.
(cont'd)
17-59