Acura 1994 Integra Service Manual page 528

Sub-shaft
Disassembly/lnspection/Reassembly
NOTE:
a Lubricate all parts with ATF during reassembly.
a Install the thrust needle bearings with unrolled edge ot bearing retainer tacing washer.
a lnspect the thrust needle bearings and the needle bearings for galling and rough movement.
a Before installing the O-rings, wrap the shaft splines with tape to prevent dsmaging the O-.ings.
TRANSMISSIOI{ HOUSING
TRANSMISSION
HOUSING BEARING
6 x 1 . 0 m m
1 2 N . m
lST-HOLD CLUTCH
ASSEMELY
O.RINGS
Replace.
THRUST WASHER
THRUST NEEDLE
BEARING
NEEDLE BEARING
4TH GEAR
THRUST I{EEDLE
AEARIIIG
4TH GEAB COLLAR
NEEDLE EEARING
(1.2 kgf.m, 8.7 lbf.ft)
SUB.SHAFT
Check splines tor excessive
wear or damage.
Check bearing surlace tor
sconng. scratches or excessive
OIL GUIDE CAP
Replace.
NEEDLE BEARIT{G
STOPPER