Acura 1994 Integra Service Manual page 124

Rocker Arms
Installation
1 . I n s t a l l t h e r o c k e r a r m s i n t h e r e v e r s e o r d e r o f
removal:
. Valve adjusting locknuts should be loosened and
adjusting screw backed off before installation.
. The component parts must be reinstalted in the
original locations.
2.
Installthe lost motion assemblies.
3. Install the rocker arms while insening the rocker
arm shaft into the cvlinder head
NOTE: Remove the rubber band after installing the
rocKer arms.
'/'/
12 mm EOLT
4 . Clean and install the rocker shaft orifices with new
O - r i n g s . l f t h e h o l e s i n t h e r o c k e r a r m s h a f t a n d
cylinder head are not in line with each other, screw
a 12 mm bolt into the rocker arm shaft and rotate
the shaft.
NOTE: The shapes of the rocker shaft orifices for
the intake and €xhaust are different. The orifices
must be installed in the original locations.
INTAKE ROCKER
SHAFT ORIFICE
Clean.
EXHAUST ROCKER
SHAFT ORIFICE
C l 6 a n .
O.RING
Beplace.
Beplace.
6-64