Acura 1994 Integra Service Manual page 138

1 1 .
12.
1 3 .
Cylinder Head
Installation lcont'd)
lnstallthe timing belt lsee page 6-51).
Adjust the valve clearance (see page 6-44).
Install the rubber seal in the groove of the cylinder
head cover. Seat the seal in the recesses for the
camshaft first, then work it into the groove around
the outside edges.
NOTE:
. B e f o r e i n s t a l l i n g t h e r u b b e r s e a l . t h o r o u g h l y
clean the seal and the groove.
. W h e n i n s t a l l i n g , m a k e s u r e t h e s e a l i s s e a t e d
securely in the corners of the recesses with no
gap.
COVER
6-78
14. Apply liquid gasket to the rubbe. seal at the eight
corne.s of the recesses.
NOTE:
.
Use liquid gasket, Part No. 08718 - 0001.
. Check that the mating surfaces are clean and dry
before applying liquid gasket.
a Do not install the parts if 20 minutes or more
h a v e e l a p s e d s i n c e a p p l y i n g l i q u i d g a s k e t .
Instead,.eapply liquid gasket after removing old
residue.
r After assembly, wait at least 20 minutes before
filling the engine with oil.
Apply liquid gasket to
the shaded areas.