Acura 1994 Integra Service Manual page 600

8.
Pack the inboard joint with the ioint grease included
in the new driveshaft set.
Grease quantity; 120 - 130 g 11.2 - 4.6 ozl
9.
Fit the inboard joint onto the driveshaft.
NOTE;
.
Reinstall the inboard joint onto the driveshaft by
aligning the marks on the inboard ioint and the
rollers.
. Hold the driveshaft so the inboard joint points up
to prevent it from falling off.
Left drivoshaft:
A l i g n t h e h o l d e r d i r e c t i o n o f t h e r o l l e r s
t o w a r d t h e s l o t o t i n b o a r d j o i n t a s
INBOARD
JOINT
/,.-:--\\\
\
I
sotine di,ection
A\
{(@}
HOLDER
1 0 . Adjust the length of the driveshafts to the figure
below. then adjust the boots to halfway between
full compression and full extension.
NOTE: The ends of boots seat in the groove of the
driveshaft and joint.
Left: 475 - 480 mm {18.7 - 18.9 inl
Right: 475 - 480 mm (18.7 - 18.9 inl
lnstall new boot bands on the boots, and bend both
sets of locking tabs.
Lightly rap on the doubled-over portions to reduce
their height.
{cont'd)
1 1 .
1 6-9