Acura 1994 Integra Service Manual page 643

7 . Submerge the valve in a container of power steer-
ing fluid or solvent, and blow in the hose. lf air bub-
b l e s l e a k t h r o u g h t h e v a l v e a t l e s s t h a n 1 0 0 k P a
11.0 kgf/cm,, 14.2 psi), replace or repair it as follows.
AIR PRESSURE
i-
POWER STEEBING
FLUID or SOLVENT
8, Hold the bottom end of th€ valve with a oDen end
wrencn.
9. Unscrew the seat in the top end of the valve, and
remove any shims, the relief check ball, relief valve
and relief valve spring,
REUEF VALVE
RELIEF CHECK BALL
sHrM(sl
lf us€d.
SEAT
13 N.m
11.3 ks[.m, I lbf.tt]
Clampthis end in
a vise with sott iaws.
FLOW CONTROL VALVE
REUEFvALvE
SPBING
10. Clean all the parts in solvent, dry them off, then
reassemble and retest the valve. Sge page 17-43 for
f low control valve installation.
NOTE: lf necessary, relief pressure is adiusted at
the facto.y by adding shims under the check ball
seat. lf you found shims in your valve, be sure you
reinstall as many as you took out,
'\)4.
nlll
Pump Rotor Removal
CAUTION: Tho pump components are made ot alu-
minum. B€ car6ful not to damage them when servicing.
1. Remove the inlet joint and O-rjng.
13 x 1.9 mm
O.RING
Replac€.
2.
Remove the pump cover and O-ring.
PUMP COVER
58.5 x 1.5 mm
O.RING
Feplace.
(cont'd)
17-37