Acura 1994 Integra Service Manual page 580

Differential (B18c1 eng:nel
Bearing Outer Race Replacement
CAUTION: Do not rous€ the thrust lhim and tho 79.8
mm shim il tho outer rac6 was ddvon out.
N O T E ;
a The bearing outer race and taper€d toller bearing
should be reDlaced as a set.
a Inspect and adjust the tapered roller bearing proload
whenever th€ tapered roll€f bearing is roplac€d.
1 . Remove the oil seals from the transmission housing
and clutch housing (see page 15-13).
2. Remove the bearing outer raca, the thrust shim, and
the 79.5 mm shim from th€ transmission housing.
Remove the bearing outer racs and thrust shim trom
the clutch housing.
TRANSMtSStOl{ HOUStl{c
15-14
5. lnstall the oil sesl (see page 15-171.
4 . Install the new thrust shim and 79.5 mm shim, then
drive the bearing outer races in the both housings
using the special tools as shown.
NOTE:
a Install the bearing outsr race squarely.
a Check that there is no clearance between tha
bearing outer race, thrust shim, and transmission
housing.
BEARIl{G
OUTER
07749-OOTOOOO
ONNER
ATTACHMENT
OTttAD-PX/IOlOO