Acura 1994 Integra Service Manual page 423

Description
Hydraulic Flow (cont'dl
@
or @ Position
1 . l s t S p e € d
The flow of fluid throuth the torque convener circuit is the same as in S
Oosition.
The line pressure ( 1 ) becomes line pressure (4) and it becomes the 1 st clutch pressure (1O). The I st ctutch pressure
is applied to the lst clutch and l st accumulator; consequently, the vehicle will move as the engine power is transmitted.
The line pressure (1) becomes the modulator pressure (6) by the modulator valve and travels to 1-2 and 3-4 shift valves.
The 1-2 shift valve is moved to the right side because the shilt control solenoid valve A is turned off and B is turned
on by the TCM. This valve stops 2nd clutch pressure and power is not transmitted to the 2nd clutcn.
Line pressu.e {4) also tlows to the seryo valve and line pressure (1 } also flows to throttle valve B.
NOTE:
. When used, "left" or "right" indicates direction on the flowchart.
. SOL-@: Shitt Control Solenoid Valve A
. SOL-@:Shift Control Solenoid Valve B
. SOL-O: Lock-up Control Solenoid Valve A
. SOL-@: Lock-up Control Solenoid Valve B
14-32
I