Acura 1994 Integra Service Manual page 542

Transmission Housing Bearings
Mainshaft/Countershaft Bearing Replacement
1. To remove the mainshaft and counte.shaft bearings
trom the transmission housing, expand each snap
ring with snap ring pliers, then push the bearing out
using the special tools and a press as shown,
NOTE: Do not remove the snap rings unless it,s
necessafy to clean the grooves in the housing.
ATTACHMENT,
6 2 x 6 8 m m
I
o7746-
---7i
\ )
MAINSHAFT
Mainshaft Removal uaoi
ATTACHMENT-
72 ,, 75 mm
o7746-OOlO600
Counterrhaft Removal uao:
ATTACHMENT,
6 2 x 6 8 m m
07746-O010500
TRANSMISSION
t|oustitc
PRESS
14-152
SNAP BING
Expand each snap ring with snap ring pliers, insert
the new bearing pan-way into the housing using the
specialtools and a press as shown. Installthe bear-
ing with the groove tacing outside the housing.
NOTE: Coat all parts with ATF.
Release the pliers. then push the bearing down into
the housing until the ring snaps in place around it,
DRIVER
o7749-OOIOOOO
GnoovE
Mainshatt Inltallation us6:
ATTACHMENT,
7 2 x 7 5 m m
07746-0010600
Counto.shalt In3talldtion uso:
ATTACHMENT.
6 2 x 6 8 m m
07746-O010500
4 . After installing the bearing verify the lollowing:
a The snap ring is seated in the bearing and hous-
In9 grooves.
a The snap ring operates properly
a The ring end gap is correct.
END GAP: O-7 mm