Acura 1994 Integra Service Manual page 385

Transmission
Reassembly (cont'd)
Installthe dowel oins.
I n s t a l l t h e t r a n s m i s s i o n h o u s i n g b y a l i g n i n g t h e
groove in the housing with finger on the stopper
.ing.
GROOVE
22. Lower the transmission housing with the snap ring
pliers and set the snap ring in the groove of tha
countershaft bearing.
TNANSMISSION
HOUSING
20.
2 1 .
13-44
23, Check that the snap ring is securely seated in the
groova of th€ countershaft bearing.
Dimcntion O as inst.lbd: il.6 - 8.3 mm
(0.181 - 0.327 inl
Install th6 transmission hang€r A and back-up light
switch clamp, thon tighten th6 transmission hous-
i n g a t t a c h i n g b o l t s i n t h e n u m b e r € d s e q u o n c o
shown below.
6 | i.25 mrn
2t
.m l2.8 lgf.m, 20 lbf.ftl