Acura 1994 Integra Service Manual page 933

ALIGNMEI{T MARKS
REAR WINDOW
16. Use suction cups to hold the rear window over the
opening, align it with the alignment marks made in
step 7, and set it down on the adhesive. Lightly push
on the rear window until its edges are fulty seated
on the adhesive all the way around,
NOTE: Do not open or close the doors until the
adhesive is drv.
17. Scrape or wipe the sxcess adhesive otf with a Dut-
ty knife or towel,
NOTE: To remove adhesive lrcm a painted swface
or the rear window, use a soft shop towel damDened
with alcohol.
1 8. Let the adhesivs dry tor at least one hour, then spray
watgr over the raar window and check tor leaks.
Mark leaking areas and let the rear window dry, then
seal with sealant.
NOTE: Let the car stand for at least tour hours al_
ter rear window installation. lf the car has to be used
within the first four hours, it must be driven slowlv.
19. Reinstall all remaining removed parts.
Rear Window Molding
Replacement
1. Remove the rear window, then remove the uppGr
seal.
2. Place the rear window on its surface, as shown, with
a helper holding the rear window.
CAUTION: Avold setting the rea? ryindow on h!
odgos: small chips may latol dovolop into cracka.
3. Cut the inner side rubber portion O olf the molding,
then cut the top rubber portion @.
REAR
wtNDow
4. Turn the rear window over, then cut the outer side
rubber portion @ of the motding.
5. Scrape all traces of old molding trom the chamtered
edges of the glass.
NOTE: Be sure to scrape all traces of old molding
thoroughly.
6. Clean the rear window su.tace with alcohol where
new molding is to be installed.
NOTE: Make sure the su.face is kept tree of waler,
oil and grease.
{ c o n t ' d l
20-65