Acura 1994 Integra Service Manual page 597

Driveshafts
Disassembly (cont'd)
3,
Mark each roller and inboard joint to identify the
locations of rollers and grooves in the inboard joint.
Then remove the inboard joint on the shop towel.
NOTE: Be careful not to drop the rollers when sepa-
rating them from the inboard joint.
INBOARD JOINT
Check splines tor w6ar or damage.
Ch€ck inside bore for wear.
Inspect tor cracks.
Mark the rollers and spider to identify the locations
of rollers on the spider. Then remove the rollers.
Remove the circlip.
Mark the spider and driveshaft to identify the posi-
tion of the spider on the shaft.
Remove the spider using a commercially available
bearing remover.
Remove the stopper ring.
BEARING
STOPPER RING
Marka
o .
,'0
CIRCLIP
1 6 - 6
ROLI-€R lFor loft ddvcshrfrl
9. Wrap the splines on the driveshaft with vinyltape to
prevent damage to the boots and dynamic damper.
10. Remove the boot band and inboad boot.
CAUTION: Take car. not to damage th€ boot.
1 1 . R e m o v e t h e d y n a m i c d a m p e r b a n d a n d d y n a m i c
damoer.
CAUTION: Tako cars not to damage the dynamic
damper.
12. Remove the boot bands and outboard boot, then
remove the vinyltape.
CAUTION: Take csre nol to damage tho boot.
INBOARD BOOT
Inspect lor cracking,
splitting and wear.
DYNAMIC DAMPER
Check tor damage.
DYNAMIC DAMPER
13. Inspect the outboard joint for faulty movement and
wear. lf any roughness or excess play is felt, replace
the outboard joint.
14. Check the outboard ring for damage.
OUTBOARD BOOT
lnspect for cracking,
splining and wear.
OUTBOARD JOINT