Acura 1994 Integra Service Manual page 661

Apply power steering fluid to the surface of the spe-
cial tool. Set the new seal rings over the special tool
f r o m t h e s m a l l e r d i a m e t e r e n d o f t h e t o o l , a n d
expand the seal rings. Do two rings at a time from
each end of the sleeve,
NOTE:
. Do not over-expand the seal ring. Install the resin
seal rings with care so as not to damage them.
After installation, be sure to contract the seal
rings using the specialtool {sizing tool}.
. There are two types of sleeve seal rings: black
a n d b r o w n . D o n o t m i x t h e d i f f e r e n t t y p e s o f
sleeve seal rings as they are not compatible.
Set the special tool in the grooves in the sleeve. and
set each ring in each groove securely.
NOTE: After installation, compress the seal rings
with your fingers temporarily.
BALL JOINT BOOT CLIP GUIDE
o?MAG - SL001d)
14. Apply power steering fluid to the seal rings on the
sleeve and to the entire inside surface of the special
tool.
15. Insert the sleeve into the specialtool slowly.
1 6 . M o v e t h e s l € e v e e a c h d i r e c t i o n s e v e r a l t i m e s t o
make the seal rings snugly fit in the sleeve.
NOTE: Be sure that the seal rings are not turned up.
SLEEVE SEAL RING
SIZING TOOL
1 3 .
07974 - 5450200
Cutout,
't7.
Apply power steering fluid to the surface ol the pin-
ion shaft, then assemble the sleeve over the pinion
shaft, aligning the locating pin on the inside of the
sleeve with the cutout in the shaft,
NOTE: Be careful not to damage the valve seal ring
when inserting the sleeve.
Install the circlip securely in the pinion shaft groove.
NOTE: Install rh€ circlip with its tapered side facing
O U I .
19. Apply power steering fluid to the seal ring lip of the
v a l v e o i l s e a l . T h e n i n s t a l l t h e s e a l i n t h e v a l v e
housing using a hydraulic press and special tools as
shown.
1 8 .
ATTACHMENT,
3 2 x 3 5 m m
077{6 - 0010100
{cont'd)
VALVE OIL SEAL
1 7 - 5 5
ir