Transmission Assembly; Lnstallation - Acura 1994 Integra Service Manual

Transmission Assembly
1. Inst€llthe dowel pins on the clutch housing.
2. Apply grease to the parts as shown, then install the
release fork and release beaaing.
N O T E : U s e o n l y S u p e r H i g h T e m p U r e a G r e a s e
(P/N 08798 - 9002).
3. Install the release fork boot.
lnstallation
22 tbt-ttl
BELEASE FORK BOLT
29 N.m (3.0 kgl.m, tPlN 08798 - 90021
RELEASE
BEARING
@
I
{P/N 08798 - 90021
P l a c e t h e t r a n s m i s s i o n o n t h e t r a n s m i s s i o n i a c k ,
and raise it to the engine level.
Install the transmission mounting bolts and the rear
mount bracket bolts
sELF-LocKrNG BoLT
RELEASE REEASE
FORK
FORK
BOOT
12 x 1.25 mm
6it N.m 16.5 kgl.m, 47 lbf.ftl
R e p l a c e .
1 4 x 1 . 5 m m
13-46
6, Raise the transmission, then install the transmission
mounI.
N O T E : T o r q u e t h e m o u n t i n g b o l t a n d n u t s i n t h e
sequence shown.
CAUTION: Check that the bushings are not twistod
or offset,
O 12 x 1.25 mm
54 N.m {6.5 kgt m,
47 tbtfrl
7. Install the three upper transmission mounting
and lower starter motor mounting bolt.
bolts
10 x 1.25 mm
44 N.m lil,s kgt m,
33 tbf.ftl
@ 12 x 1.25 mm
7,1 N.m 17.5 kg{.m,
5/r lbtftl
1 2 x 1 . 2 5 m m
64 N.m 16.5 kgf.m, 47 lbf.ftl