Acura 1994 Integra Service Manual page 936

Hide thumbs Also See for 1994 Integra:

Table of Contents

a Wear gloves to remove and install the leal window.

a Do not damage the delloster grid lines.

1. To remove the rear window, f irst remove:

. Trunk lid {see page 20-149)

a Rear seat-back side bolsters (see page 20-11 1)

. Rear shelf (see page 2O-95)

a Rear pillar trim panel {see page 20 95)

Disconnect the defroster leads, and remove their

NOTE: Avoid scratching the rear window with the

cutter blade.

3. Remove the clips, then remove the lower cover.

NOTE: Use a clip remover to remove lhe clips.

Peel off the molding.

NOTE: When molding removal is difficult, cut the

molding with a knife.

Pull down the rear of the headliner (see page

2 0 - 1 0 1 ) .

CAUTION: Take care not to bend the headliner ex-

Apply protective tape to the edge of the body, as

Using an awl. make a hole through the adhesive from

inside the car. Push the piano wire through the hole

and wrap each end around a piece of wood.

/ - a,o*o *'*a

LowERsPAcER/

LowER FASTENER oore,srvr \3

PROTECTIVE TAPE

Show Quick Links

Chapters

Table of Contents

Integra 1994