Acura 1994 Integra Service Manual page 225

Troubleshooting
Self-diagnostic Procedures
When the Malfunction Indicator Lamp {MlL) has been reported on, do the following:
'1.
Connect the SCS short connecto. to Service Check Connector as shown. (The 2P Service Check Connector is
located under the dash on the passenger side of the car.) Turn the ignition switch on.
DATA LII{K
CONNECTOR (3PI
NOTE:
Do not attach
jumper wire.
2. Note the Diagnostic Trouble Code (DTC): The MIL indicates I code by the length 8nd numbsr ot blinks. The MIL
can indicate multiple component problems by blinking separate codes, one after another. Codes 1 through Igre
indicated by individual shon blinks. Codes 1O through 43 are indicated by a series of long and shon blinks. Th€
number of long blinks equals the first digit, the number ot short blinks equals the second digit. Sometimes the
firsr blink is difficult to see; always count the blinks at least twice to verify the code.
MALFUNCTIOI{
INDICATOR
LAMP
CANADA:
CHECK
ENGINE
LIGHT
IMIL}
Sgprrate Prcbaomr:
shT
-n-----n- =n-
= s.o DTc 1
+!+1].TL;I!!=-
= s.. Drc 3
-L
,JU
'" " "
= Sce DTC 13
Long .hon
Multiplr Probl.ln.:
J-l_tx-TL-n-ffu-r-
= S€. DTC 1 lnd 3
-J.rrU-L-r]tltlr'l-
__-tnrua = Sce DTC 3 and 4
Jll-lrl-t-----Tt/'tnj]_
= S.. DTC 3 lnd 14
11-34