Acura 1994 Integra Service Manual page 638

Steering Column
Installation (cont'dl
F i n a l t o r q u e :
22 N.m
{2.2 kgf.m, 16lbt.ftl
CAUTION:
. All SRS electrical wiring hrrnossos are covgrod wilh
yellow insulation,
. When disconn€cting the SRS wire harness, install
the short connector on the airbag. th€n dbconnoct
the wire harness.
. Replaca the entire alfected SRS harness assembly if
there is an open circuit or damage to tho wiring.
1. Slip the upper end of the steering joint onto the col-
umn shaft {line up the bolt hole with the flat on the
shaft), and loosely install the upper steering joint
bolt.
UPPER STEERING JOINT BOLT
Bolt must line up with
flat on shaft.
STEERING
JOINT
Slip the lower end of the steering joint onto the pin-
i o n s h a f t . L i n e u p t h e b o l t h o l e w i t h t h e g r o o v e
around the shaft) and loosely jnstallthe lower bolt.
NOTE:
. B e s u r e t h a t t h e l o w e r s t e e r i n g j o i n t b o l t . i s
securely in the groove in the steering gearbox
p i n i o n .
. Before tightening the steering joint bolts, pull on
the sleering joint to make sure that the steering
joint is fully seated.
LOWER STEERING JOINT BOLT
F i n 6 l t o r o u e :
22 N.m {2.2 kgt m. 15 lbf.ftl
17 -3 2
I n s t a l l t h e s t e e r i n g c o l u m n w i t h t h e f l a n g e n u t s ,
then installthe column holder and flange bolts.
Tighten the upper and lower steering joint bolts
loosely installed in steD 2,
FLANGE BOLTS
22 N.m
12.2 ksi.m, 16 tbtftl
Install the steering joint cover with the clamps and
clip.
CLIP