Acura 1994 Integra Service Manual page 657

20. Apply vinyl tape to the pinion shaft.
Separate the valve housing from the pinion shafv
valve using a press.
VALVE HOUSING
Vinyl t.p.
Check the inner wall of the valve housing where the
seal ring slides with your finger. lf there is a step in
t h e w a l l , t h e v a l v e h o u s i n g i s w o r n . R e p l a c e t h e
valve housing.
NOTE:
There may be the sliding marks from the seal
ring on the wall of the valve housing. Replace
the valve housing only the wall is stepped.
When the valve housing is replaced, install new
3 2 m m s h i m ( s ) o n t h e b e a r i n g s u r f a c e o f t h e
housing to adjust the thickness.
2 1 .
22.
2 3 . C h e c k f o . w e a r . b u r r s a n d o t h e r d a m a g e t o t h e
edges of the grooves in the sleeve.
NOTE: The pinion shaft and sleeve are a precision
matched set. It either the pinion shaft or sleeve
must be replaced, replace the both parts as a set.
SLEEVE SEAL RINGS
Ch6ck for oeel off or
o a m a g 0 ,
24. Remove the circlip and pinion shaft sleeve from the
oinion shaft.
(cont'd)
17-51