Acura 1994 Integra Service Manual page 144

BEARING
CAP BRIDGE
No. a 3, /a CAP BOLTS
l l x 1 . 5 m m
64 N.m {6.5 kgt m,
49 tbf.ftl
Apply engine oilto tho bolt
threads and the washers.
NOTE: Aftertorquing
each cap, turn crankshaft
to check for binding.
No. 1,5 CAP BOI-TS
11 x 1.5 mm
73 N.m {7.4 kgf.m,
56 tbt'ft|
Apply engine oil.
BEARING CAP
CRANKSHAFT
End play, page 7-12
Runout, Taper, and
Out-of-Round, pages 7'12. 13
Installation, page 7-22
YHRUST WASHERS
Grooved sides lace outward.
NOTE: Thrust washer thickness
is fixed and must not be chano€d
MAIN BEARING
Radial clearance. page 7 8
S6l€ction, page 7-8
NOTE: New main bearings
must be selected by matching
crank and block identification
marxrngs.
OIL JEI BOLY
16 N.m 11.6 kg{'m, 12lbtftl
Be caretul not to damage.
OIL PUMP
Overhaul, page 8-9
Apply liquid gasket
to block mating
surface.
OIL SEAL
Installation,
pages 7-25, 26
11 N.m 11.1 kgt m,
8 lbf ftl
Replace.
6 r 1 . 0 m m
OIL JET
Inspection,
page 8-8
OIL SEAL
Instellelion,
page 8-11
Replace.
RIGHT SIDE
COVER
Apply liquid gasket
to block mating
surface.
6 x 1 . 0 m m
11 N.m {1.1
8 rbf.ftl
kSf.ft,
DOWEL PIN
DOWEL PIN
O.RING.
Apply engine
o r l .
Replace.
8 x 1.25 mm
24 N.m {2.4 kgt m,
17 tbtft)
(cont'd)
7-5