Acura 1994 Integra Service Manual page 490

Transmission
Removal
4 . Bemove the t.ansmission ground cable from the
transmission hanger.
Disconnect the lock-uD control solenoid valve con-
nector and the shitt control solenoid valve connec-
tor, then remove the harness clamp on the lock-up
control solenoid harness from the harness stav.
a Make sur€ lifts. iacks and safety stands are placad
properly, and hoist brackots are attachod to tho cor-
rect position on ths sngine {seo sectionl }.
o Apply parking brake and block rear wheels, so car will
not roll off stands and fall on you whil6 working un-
del it
CAUTION: Use tender covers to avoid damsging paint-
ed surlaces,
1 .
Disconnect the battery negative { - } and positive ( + )
cables from the battery.
2. Remove the intake air duct and air cleaner housino
assembly.
HARNESS CLAMP
LOCK-UP CONTROL
SOLENOID VALVE
CONNECTOR
AIR CLEAI{ER
HOUSING ASSEMBLY
SHIFT CONTROL
SOLENOID VALVE
CONNECTOR
TRANSMISSION
GROUND CABI-E
Disconnect the vehicle speed sensor (VSS), main-
shaft sDeed sensor and countershaft speed sensor
connectors.
3 .
Remove the starter motor cables and cable holder
from the starter motor.
VEHICLE SPEED
SENSOR CONNECTOR
STARTER MOTOR CABLE
CABLE HOLDER
VEHICLE SPEED
SENSOR
COUNTERSHAFT
SPEED SENSOR
CONNECTOR
MAINSHAFT SPEED
SENSORCONNECTOR (cont,d)
STARTER MOTOR
?/\
STARTER M
OTOR CABLE
4-99