Acura 1994 Integra Service Manual page 145

lllustrated Index
F
(cont'd)
NOTE: New rod bearings must be selected by
connecting rod and crankshaft identification
( s e e p a g e s 7 - 8 , 9 )
matching
m a r K r n g s
Lubricate all internal parts with engine oil during
reassemorv.
PISTON RINGS
Replacement, page 7'16
Measurement. page 7-17
Alignment, page 7 18
PISTON PIN
Removal, page 7-18
lnstallation, pages 7 19, 20
Inspection, page 7'20
PISTON INSTALLATION DIRECTION
EXHAUST
INTAKE
Removal, page 7'11
Measurement, page 7 15
Inspect top of each cylinder bore
for carbon build-up or ridgo
betore removing piston.
Remove ridge it necessary, page 7'11
CONNECTING ROO
End play, page 7-21
CONNECTING ROD
EEARINGS
Clearance, page 7-9
Selection, page 7-9
CONNECTING ROD NUT
818B1 ongine
8 x 0 . 7 5 m m
31 N.m {3.2 kgf.m,23 lbf ftl
818C1 engine
9 x 0.75 mm
a,a N.m (4.5 kgt m, 33 lbf.ft|
After torquing each bearang
cap, rotate crankshaft to
check for binding.
r-(,
Selection, page 7-22
Small end measurement. page 7-21
BLOCX
Cylinder bore inspection, page 7 13
Warpage inspection, page 7'14
Cylinder bore honing, page 7-14
CONNECTING ROD BEARING CAP
Installation, page 7'23
NOTE: Install caps so the bearing recess is
on the same side as the recess in the rod.
r@
-1@