Acura 1994 Integra Service Manual page 934

Rear Window Molding
Replacement (cont'd)
8 .
7. With a brush. apply a light coat of glass primer
around the edge of the glass.
NOTE: Scrape otl excess glass primer with a putty
knife after installing new molding.
6 m m
1O.23 Inl
SUBFACE
INSIDE SURFACE
6 m m
(0.23 inl
Degrease the inner surfaces ol new molding
thoroughly, then apply a light coat ot glass primer
to the surtaces.
NOTE:
a Apply glass primer around the entire groove of the
new molding,
a Do not apply glass primer to the outer surface.
L
Run a bead oJ adhesive in the groove of the molding'
20-66
MOLDING
JOINT
1 O. Place the rear window outside-up. then align the joint
ot the molding with the
"T" mark at the top ot the
glass as shown.
MOLOING
1 1 .
wtNDOW
Press the molding into position around the entire
edge of the rear window.
NOTE: Check that the molding is not wrinkled or lift-
ed awav at corners.
MOLDING